Pottery Barn's version:
Well I finally got around to whipping up my own version and I am here to share how you too can make a rustic wood clock for a fraction of Pottery Barn version!
When Tim was prototyping his Steel Pipe Table, it took him a while to figure out how to make sure his wood disc top would not split. This left me with a few "imperfect" discs to play around with. After a few ideas, I settled on creating a clock out of this perfectly imperfect piece of wood.
Step 1- So, your first step is to figure out the face of your clock.
You probably don't have a extra wood disc lying around, but here are a couple of ideas if you need them.
Walnut Hollow sells these two clock faces below for a mere $7 and $10. You can buy them here or here.
If you prefer a more reclaimed look, you could use old wood flooring or even beat up 1x4's. You can stabilize the piece in the same way I built my wooden busts. You simply use a piece of 1X2 and screws as a cleat to hold the pieces together. Construction adhesive also helps.
Step 2- Stain your clock face.
Step 3- Next, it's time to sketch out your border and numbers.
Step 4- Paint your roman numerals into the wood -or- go with my other suggestion.
I chose to simply paint my numbers onto the wood, but if you wanted to create more of the iron look that the Pottery Barn version boasts, you could cut the roman numerals out of poster board and then use the metallic hammered iron spray paint (found at most hardware stores) to make them look more dimensional.
Step 5- Assemble and attach your clock pieces. You can find these kits at most craft stores- Hobby Lobby, Michael's, ect. There will be instructions included in the package, but basically you drill a hole for the metal piece to poke through, slide on your hands onto the metal piece, and then use a tiny washer to secure everything.
Our wood disc was thicker than all the other suggestions I gave you, so Tim had to route out a place for the clock mechanism in order for the piece to fit correctly. Take this into consideration when you are deciding on what you will use for the clock face.
Step 6- Display your clock!
Here's how mine turned out!
So what do you think? Do like my imperfect piece of wood? Do you wish I would have made the roman numerals more dimensional? Are you going to make one for yourself? Do tell!